Zoom ST-224 - Manual (Page 65)

• To store WAV files or AIFF files on a data card for the ST-224, a
computer capable of reading and writing MS- DOS format data
cards is required.
• If "--" is shown in place of XX, the data card does not contain
any of the files described above.
• When wishing to recall a preset sound, store the contents of the
main memory and backup memory to a data card as required,
and then reset the ST-224 to the factory default condition
(
➔ p. 69 ). By storing the present sounds on a data card,
recalling of specific waveform data becomes possible. This is a
handy feature.
• If "int" or "CArdXX" was selected in step 2
Proceed to step 4.
• If "FILEXX" or "AIFFXX" was selected in step 2
Proceed to step 5.
If "CArdXX" was selected in step 2, the bank number and pad
number for the desired data within the bulk data must be specified
before proceeding to step 5. When the [LOAD] key is pressed, the
bank number (1 - 3) and pad number (1 - 8) for the source appear on
the display. Specify the desired numbers here.
When the [LOAD] key is pressed, the bank number (1 - 3) and pad
number (1 - 8) for the target appear on the display. Specify the
desired numbers here.
If "int" or "CArdXX" was selected in step 2, the waveform data and
pad parameters are loaded into the specified pad. If "FILEXX" or
"AIFFXX" was selected, waveform data only are loaded into the
specified pad.
When reading in a WAV file or AIFF file, the sampling frequency and
tuning parameters are automatically converted.
For details, see the section "ST-224 File Import Details" on
page
72 .
HINT HINT
65
Storing
and
Reading
Data
BPM/VALUE
MEASURE SAMPLE/SONG BEAT
Bank number
Pad number
BPM/VALUE
MEASURE SAMPLE/SONG BEAT
Bank number
Pad number
+ –
[–] [+] keys
BANK 1
BANK 1– 3 keys
Pads 1 – 8
BACKUP
LOAD SAVE INTERNAL/DATA CARD
BACKUP
LOAD SAVE INTERNAL/DATA CARD
BANK 1
BANK 1– 3 keys
Pads 1 – 8
BACKUP
LOAD SAVE INTERNAL/DATA CARD
If "int" or "CArdXX" was selected in step 2, press the [LOAD] key and use the [BANK 1] -
[BANK 3] keys and pads 1 - 8 to select the load source bank number and pad number.
4 STEP
Press the [LOAD] key and use the [BANK 1] - [BANK 3] keys and pads 1 - 8 to select the
load target bank number and pad number.
5 STEP
To execute the loading process, press the [LOAD] key again. 6 STEP
Use the [-] [+] keys to select the file number (1 - 99).
3 STEP
NOTE