Setting the sample playback position, P. 29, Therefore repeated sampling is not necessary even – Zoom ST-224 User Manual
Page 29: Step, Step setting the sample playback position, Press the [pad function] key, Hint
29
Pad
Play
Mode
Operation
The [PAD FUNCTION] LED flashes.
The [PAD FUNCTION] LED and the LED of pad 3 are lit.
Pressing the [PAD FUNCTION] key and then pad 3 enables the
setting of the start point. All sample playback stops.
While the pad is held down, the sample assigned to the pad plays in
a loop.
The address of the currently set start point
is shown on the display. If the start point
has not been set, "000000" is shown.
After assigning a sample to a pad, the following three parameters can be changed to specify the playback
position.
• Start point
Normal playback start point. When the pad is pressed,
playback starts from this point.
• End point
Normal playback end point. During one-shot playback,
playback ends when this point is reached. During loop
playback, playback returns to the start point when this
point is reached.
• Offset
By selecting this value, the playback start position can be
shifted forwards. During one-shot playback, playback
starts at the offset point and stops at the end point.
During loop playback, playback starts at the offset point
and returns to the start point when the end point is
reached.
When there is a blank at the beginning and end of the sample, it can be eliminated by
moving the start point and end point.
HINT
HINT
BANK
3
BANK
2
BANK
SONG
PAD
1
FUNCTION
PAD ASSIGN CAPACITY
ERASE OPTIMIZE
PLAY/STOP
RECORD
EDIT 2
HIGH-PASS
DISTORTION
RING MODULATOR
DIMENSION
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
LOOP/MARK
4
SHIFT
OFFSET
6
SWING
PANNING
8
MIDI
TRIGGER/GA
TE
2
QUANTIZE
TUNING
SOURCE
SOURCE MIX
5
PRE COUNT
END POINT
3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL
7
CLICK VOLUME
REVERSE
COPY
DELETE
BACKUP
EXIT
SPECIAL
LOAD
SAVE
INTERNAL/DATA CARD
+
–
AUTO SYNC
TAP
BPM
MEASURE
SAMPLE/SONG
BEAT
q y
u o
e
r
et
w
o
u
SONG
PAD
FUNCTION
3
TIME SIG
START POINT
Press the [PAD FUNCTION] key.
1
STEP
To set the start point, press pad 3 (START POINT).
2
STEP
Use the [BANK 1] - [BANK 3] keys and the pads 1 - 8 to select the pad for which to set the
start point.
3
STEP
Setting the Sample Playback Position
Sample
Start point
[One-shot playback]
[Loop playback]
[One-shot playback]
[Loop playback]
End point
End point
Sample
Start point Offset point
BANK
1
BANK 1– 3 keys
Pads 1 – 8
BPM/VALUE
MEASURE
SAMPLE/SONG
BEAT