Zoom ST-224 - Manual (Page 34)

The [COPY] LED flashes and the bank number (1 - 3) and pad number
(1 - 8) of the copy source are shown on the display.
The copy source is selected.
The copy is carried out. To cancel the copy process, press the [EXIT]
key.
The settings for a given pad (sample number, playback position, playback method, etc.) can be copied to
another pad. This is useful for example when wishing to play the same sample with two pads, while changing
only the tuning and panning settings.
BANK 3
BANK 2
BANK
SONG
PAD
1
FUNCTION
PAD ASSIGN CAPACITY ERASE OPTIMIZE
PLAY/STOP RECORD
RE-SAMPLE GRADE MONO
STEREO
SAMPLING
EDIT 2
VOLUME/BASS
EXCITER
TREMOLO
AUTO PAN
LO-FI EFFECT
EXTREME EQ
COMPRESSOR
RESONANCE
HIGH-PASS
LOW-PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
CHORUS
PHASER
FLANGER
STEP CRY
DELAY
REVERB
TIME STRETCH
SCRATCH
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
LOOP/MARK
4
SHIFT
OFFSET 6
SWING
PANNING
8
MIDI
TRIGGER/GA
TE
2
QUANTIZE
TUNING
SOURCE
SOURCE MIX
5
PRE COUNT
END POINT 3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL 7
CLICK VOLUME
REVERSE
COPY DELETE
BACKUP EXIT
SPECIAL LOAD SAVE INTERNAL/DATA CARD
+ –
AUTO SYNC
PLAYLIST
TAP BPM
SONG
PLAY/STOP REC
BPM/VALUE
MEASURE SAMPLE/SONG BEAT
COPY
BANK 1
BANK 1– 3 keys
Pads 1 – 8
BANK 1
BANK 1– 3 keys
Pads 1 – 8
COPY
COPY
Bank number
Pad number
BPM/VALUE
MEASURE SAMPLE/SONG BEAT
BPM/VALUE
MEASURE SAMPLE/SONG BEAT
Press the [COPY] key. 1 STEP
Use the [BANK 1] - [BANK 3] keys and the pads 1 - 8 to select the pad to which to copy. 4 STEP
Use the [BANK 1] - [BANK 3] keys and the pads 1 - 8 to select the pad from which to copy.
2 STEP
Press the [COPY] key. 3 STEP
Press the [COPY] key again.
5 STEP
Copying Pad Settings
34
Pad
Play
Mode
Operation