Smart Technologies 800ix-SMP - Manual (Page 42)

Connecting peripheral sources and outputs
Follow these instructions if you have a peripheral device to connect to your interactive whiteboard
system.
N
N O T E S
l
Measure the distance between the projector and the peripheral device you want to connect.
Make sure each cable is long enough, has plenty of slack and can be placed safely in your
room without presenting a trip hazard.
l
Do not disconnect cables from the ECP to connect peripheral devices because you could
disconnect controls for your interactive whiteboard.
l
Don’t connect SBA-L projection audio system speakers to the RCA connector pod. Connect
these speakers to the projector connection panel using a dual-channel (left and right) RCA
plug-to-3.5 mm phone connector (included with the speakers).
l
The composite video connector and associated dual channel audio inputs on the projector
and optional RCA connector pod are for input only. These RCA jacks don’t provide an output
signal.
g To connect a laptop to a SMART Board 800ix interactive whiteboard system
1. Connect a USB cable from the laptop computer to the ECP.
2. Connect a VGA cable from the laptop computer to the projector.
OR
Connect an HDMI cable from the laptop computer to the projector.
3. Press the Input button on the ECP or remote control to switch input sources to the laptop
computer.
g To connect a laptop to a SMART Board 800ix-SMP interactive whiteboard system
1. Connect the laptop computer to the SMART GoWire cable, and then connect the
SMART GoWire cable to the CAT 5 USB extender.
OR
Connect the laptop computer directly to the CAT 5 USB extender.
C H A P T E R 4
Integrating other devices
32