Smart Technologies 800ix-SMP - Manual (Page 79)

4. Type commands to configure your settings.
N
N O T E S
o To see a list of commands available in the current operating mode, type ? and then
press ENTER.
o If you’re using a terminal emulation program, turn on your program’s local echo setting
to see characters as you type them.
Projector programming commands
This section documents the projector programming commands.
Projector power state controls
Your projector responds to commands only at certain power states and times.
There are four projector power states:
l
Off (Standby mode)
l
Powering (startup)
l
On (operating)
l
Cooling
Command inventory
Your projector responds to the commands in the tables on the following pages. To see a list of valid
commands in the projector’s current power state, type ? and press ENTER.
I
I M P O R T A N T
When entering commands, ensure there is a 10 millisecond delay between characters for reliable
operation.
N
N O T E S
l
Send a command only after the projector sends a command prompt.
l
Commands aren’t case sensitive. Type commands exactly as they appear in the left column
of the tables, with the proper value or setting in the center column.
l
Check your entries carefully before entering your commands.
l
Press ENTER after typing each command.
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
69