Edimax Technology PT-31W - Manual (Page 11)

10
Step 8:
Insert the DI/DO signal cable(s) into the
DI/DO port. If you do not have DI/DO
accessories, you can skip this step.
Step 9:
Connect the power adapter to the network
camera, then plug the power adapter into
a wall socket. The camera’s LED lights
should light up after a few seconds, and
the camera will test its pan and tilt motor
within 1 minute. Please do not obstruct
the network camera while it is testing its
pan and tilt motor.
Step 10:
If it needs to set up wireless connection,
please attach the wireless antenna to the
IP camera and configure through wired
connection. (PT-31W only)