Edimax Technology PT-31W - Manual (Page 31)

30
SSID Input the SSID of the wireless access point you wish to connect.
It should be less than 32 alphanumerical characters. When you
select a wireless access point above, it‟s SSID will be filled in
this field automatically. However, if the SSID is not displayed
(the wireless access point you selected choose to hide it‟s
SSID), you have to know it‟s SSID and input it here, or you will
not be able to connect it.
Channel Select the radio channel you wish to use here. When network
type is „Infrastructure‟, the radio channel is auto-selected
according to the channel that wireless access point uses. You
can only select the channel number when network type is
„Adhoc‟.
Authentication It includes None, Open System, Shared Key 64bits and 128bits,
WPA-PSK, WPAS-PSK. Select one of them then the relative
items below will transfer gray scale to black scale. Configure
the setting consistent with the setting on the wireless
router/AP that this IP camera will join the wireless network.
Apply the settings then check the wireless networking.
Pin Code Here displays the WPS pin code used to connect to
WPS-enabled wireless access points. You have to input this
number into the WPS enabled access point to establish WPS