Linksys X-Series - Manual (Page 181)

6
Installation Linksys X-Series
b. Connect the gray cable to the modem-router’s DSL port and to a
telephone jack on your wall, then click Next .
You are asked to enter your ISP information .
c. Select your region, click Next, then select your ISP . If prompted, enter
your DSL account name and password .
Or, to skip the automatic detection of your region and manually
configure your Internet connection, select My region is not in this
list, then click Next . Use information available from your ISP to
complete the remaining screens for DSL settings, Internet type, and
account information .
d. Follow the on-screen instructions to finish the setup .
Set up your modem-router manually
NOTE
Run the Setup CD-ROM to install the modem-router . If you cannot
run the Setup CD-ROM, refer to the steps below .
NOTE
If you are setting up your modem-router in New Zealand, see
“NOTE FOR USERS IN NEW ZEALAND” on page 8 .
Connect your modem-router
To connect your modem-router (X1000 ports shown):
1. Power down all your network devices, including your computer(s) and
the modem-router . If you currently use a modem, disconnect it now—
the modem-router replaces your modem .
2. Connect one end of the provided Ethernet cable to your computer’s
Ethernet adapter and the other end to an Ethernet port on the back of
the modem-router .
3. Repeat step 2 for each additional computer or device that you want to
connect to the modem-router .
NOTE
If your computer’s Ethernet adapter is not set up, refer to the
Ethernet adapter’s documentation for more information .
4. Connect one end of the phone cable to the DSL port on the back .