JVC KW-NSX700 - Manual (Page 69)

69
ENGLISH
Connection/Installation
Before installing the unit
Supplied accessories
1 Wiring harness x 1
2 Trim plate x 1
3 Extension wire x 1
4 Extraction keys x 2
5 Mounting bolt (M4 x 20 mm) x 1 / Washer (ø5) x 1 /
Lock nut (M5) x 1/ Rubber cushion x 1
6 Flat head screws (M5 x 8 mm) x 8
7 Round head screws (M5 x 8 mm)* x 8
8 Microphone x 1
9 Bag for storing the Bluetooth adapter x 1
(KW-NSX600: Bluetooth adapter KS-UBT1 is also
supplied.)
0 Smartphone extension cable x 1
- Tape x 1
*
Use these screws when installing the unit without the
supplied mounting sleeve. (☞ page 71)
Installation procedure
1 To prevent a short circuit, remove the key from
the ignition and disconnect the
· battery.
2 Make the proper input and output wire
connections for each unit.
3 Connect the speaker wires of the wiring harness.
4 Connect the wiring harness wires in the following
order: ground, battery, ignition.
5 Connect the wiring harness connector to the unit.
6 Install the unit in your car.
7 Reconnect the
· battery.
8 Press the reset button.
9 Configure <Initial Settings>. (☞ page 5)
WARNING
• If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire.
Always connect those wires to the power source
running through the fuse box.
• Do not cut out the fuse from the ignition wire (red)
and the battery wire (yellow). The power supply must
be connected to the wires via the fuse.
Precautions on installation and
connection
• Mounting and wiring this product requires skills and
experience. For best safety, leave the mounting and
wiring work to professionals.
• Make sure to ground the unit to a negative 12V DC
power supply.
• Do not install the unit in a spot exposed to direct
sunlight or excessive heat or humidity. Also avoid
places with too much dust or the possibility of water
splashing.
• Do not use your own screws. Use only the screws
provided. If you use the wrong screws, you could
damage the unit.
• If the power is not turned on (“MISWIRING Check
wiring connection then reset unit”, “WARNING Check
wiring connection then reset unit” is displayed), the
speaker wire may have a shortcircuit or touched the
chassis of the vehicle and the protection function
may have been activated. Therefore, the speaker wire
should be checked.
• If your car’s ignition does not have an ACC position,
connect the ignition wires to a power source that
can be turned on and off with the ignition key. If you
connect the ignition wire to a power source with a
constant voltage supply, such as with battery wires,
the battery may be drained.
• If the console has a lid, make sure to install the unit
so that the monitor panel will not hit the lid when
closing and opening.
• If the fuse blows, first make sure the wires are not
touching to cause a short circuit, then replace the old
fuse with one with the same rating.
• Insulate unconnected wires with vinyl tape or other
similar material. To prevent a short circuit, do not
remove the caps on the ends of the unconnected
wires or the terminals.
EN_KW-NSX700/600[E].indb 69 EN_KW-NSX700/600[E].indb 69 12/11/14 13:02 12/11/14 13:02