Accu-Chek Advantage - Manual (Page 13)

Code or the test strip
symbol flashes.
Bell and “ON” or “OFF”
symbols flash.
The hour display flashes.
The minute display
flashes.
Getting Started
23
Do I have to set the time and
date? No, it is an optional
feature. However, there is a
slight possibility that one
result every seven days
could be incorrectly recorded
in the memory. If time and
date are set on your meter,
this situation will only occur
when your meter clock reads
12:00 (midnight) -12:10 a.m.
If time and date are not set
on your meter, this situation
can occur once every seven
days at any time of the day.
Do not change your thera-
py based on one individual
result recorded in memory.
Time and date should be set
prior to testing if you plan to
down-load the results into
software or if you plan to
review you memory to check
when a test was done.
T he meter is unable to
account for February 29
each leap year. Therefore,
on March 1 of a leap year
(2000, 2004, and 2008) you
will need to adjust the date
by one day.
1. Turn meter ON.
2. Press ON/OFF and
MEM buttons at the
same time.
3. Press MEM button.
4. Press and release
ON/OFF button until
the correct hour is
displayed.
5. Press MEM button.
6. Press and release
ON/OFF button until
the correct minutes
are displayed.
Setting the Time and Date
22
362-11463 AdvMan Classic-ENGL 7/15/02 12:04 PM Page 22