Pc 5150, Pc 5172 – Acnodes PC 5172 User Manual
Page 32
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at
PC 5150
15-inch touch panel PC
32
PC 5172
17-inch sunlight readable touch panel PC
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218,
4.5.1 AT/ATX Power Selection (AT_PWR_SW1)
The AT/ATX power selection switch selects AT or ATX power for the PC 5172. ATX power has more power saving capabilities
than AT power. The AT/ATX selection jumper is connected to the AT/ATX switch on the I/O panel of the PC 5172.
Table 4-2: AT/ATX Power Selection
4.5.2 Clear CMOS Setup (JP2)
If the motherboard fails to boot due to improper BIOS settings, use this jumper to clear the CMOS data and reset the system
BIOS information. To do this, use the jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to
pins 1 and 2.
If the "CMOS Settings Wrong" message displays during the boot up process, try to correct the fault by pressing the F1 to enter
the CMOS Setup menu. Then do one of the following:
Enter the correct CMOS setting
Load Optimal Defaults
After one of the above has been done, save the changes and exit the CMOS Setup menu.
Table 4-3: Clear CMOS Jumper Settings
4.5.3 Monitor Setup (JP1)
WARNING: Do not change these settings. They are set for the installed LCD panel. Using different settings on the preinstalled
monitor can destroy it.
The monitor setup jumper sets the default settings for all monitors connected to the PC 5172 .
Pins 1-4 adjust the resolution of the screen.