Pc 5150, Pc 5172 – Acnodes PC 5172 User Manual
Page 46
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at
PC 5150
15-inch touch panel PC
46
PC 5172
17-inch sunlight readable touch panel PC
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218,
4.7.3 Rack and Cabinet Installation
To mount the PC 5172 into a rack/cabinet, please follow the steps below.
Step 1: Secure the rack mounting bracket to two sides of
the monitor using the supplied retention screws (Figure 3-17).
Each bracket requires four screws.
Step 2: Secure the rack mounting bracket to the rack by inserting
and tightening the supplied mounting nuts and bolts (Figure 3-17).
Each bracket requires three nuts and bolts for installation.
4.7.4 Arm Mounting
The PC 5172 is VESA (Video Electronics Standards Association) compliant and can be mounted on an arm with a 100 mm
interface pad. To mount the PC 5172 on an arm, please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto the surface it uses as a base. To do
this, refer to the installation documentation that came with the mounting arm.
NOTE: When purchasing the arm please ensure that it is VESA compliant and that the arm has a 100 mm interface pad. If the
mounting arm is not VESA compliant, it cannot be used to support the PC 5172 flat panel PC.
Step 2: Once the mounting arm has been firmly attached to its surface, lift the
PC 5152 flat panel PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the PC 5172 flat panel PC. The PC 5172
flat panel PC arm mount retention screw holes are shown in Figure 3-18.
Figure 4-23: Arm Mount Retention Screw Holes
Figure 4-22: Tighten the Panel Mounting Clamp Screws