ACR&Artex ME406 Portable ELT - Manual (Page 69)

25-62-31
Page 69 of 85
JUN 25/13
ARTEX PRODUCTS / ACR ELECTRONICS, INC
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
ME406P (453-6611)
Figure 24. Velcro Strap Installation & Inspection
(5) Tighten the Velcro strap around the ELT body.
(a) Tighten the Velcro strap firmly around the ELT body. Pull loose end of strap with enough
force so that the stitched seam is aligned with the crown of the radius of the ELT case
(see Detail A). Press and smooth “hook” end of strap firmly into “loop” portion to ensure
a tight bond.
(b) Conduct an inspection of the Velcro strap per FAR Part 43, Appendix D. Check strap for
proper position and tightness. Check strap for debris that may inhibit the strap from
being fully engaged. Also check for cuts, abrasion, or any other damage to the strap.
Replace mounting tray assembly if any parts are damaged or worn.
(c) Repeat steps (a) and (b) each time the ELT is removed and re-installed in the mounting
tray.
(6) Connect the remote switch harness plug to the ELT, as follows:
(a) Press two sealant strips (850-0814) against the male pins of the ELT receptacle with the
tacky side against the pins, while peeling the foam backing off each sealant strip.
NOTE: Verify sealant strips match the receptacle shape.
NOTE: Verify the sealant strips are in place on existing installations.
(b) Plug the remote switch harness plug into the ELT receptacle.
(c) Screw the thumbscrews into the ELT receptacle retaining nuts until the plug is seated
properly.
A
LOOSE END
OF STRAP
DETAIL A
CROWN AREA OF
CASE RADIUS
STRAP STITCHING
ALIGNED WITH
RADIUS OF CASE.