Connecting the hose – Activeforever Invacare microAIR Lateral Alternating Pressure Mattress & Compressor (microAIR Mattress with Compressor 36 x 80 x 15) User Manual
Page 12
SECTION 2—OPERATION
MA90 and MA95 Series Mattresses
12
Part No 1148139
Connecting the Hose
CAUTION
Ensure that the hose connecting the control unit to the mattress is routed such that
it cannot be stepped on, kinked, squeezed or otherwise damaged.
NOTE: For this procedure, refer to FIGURE 2.3.
1. Locate the hose at the foot end of the mattress.
2. Locate the control unit connector on the right side of the control unit.
3. Perform one of the following:
• MA90Z Power Unit ‐ Perform the following steps (Detail “A”):
i. Squeeze and hold the tabs on the hose connectors.
ii. Insert the hose connectors into the control unit connector.
iii. Push the hose connectors onto the control connector until an audible click is
heard.
NOTE: The audible click indicates that the hose connector(s) are properly engaged with the
control connectors.
• MA95Z Power Unit ‐ Perform the following steps (Detail “B”):
i. Lift and hold the connector cover up.
ii. Push the hose connector onto the control connector.
iii. Ensure the hose connector is flush with the control unit connector.