Activeforever Invacare microAIR Lateral Alternating Pressure Mattress & Compressor (microAIR Mattress with Compressor 36 x 80 x 15) - Manual (Page 21)

SECTION 2—OPERATION
Part No 1148139 21 MA90 and MA95 Series Mattresses
4. Raise or lower the bed to match the gurney height. Refer to the owner’s manual
provided with the bed.
5. When the mattress has reached maximum firmness, perform one of the following:
• Bed to Gurney Transfer ‐ Slide the patient onto the gurney.
• Gurney to Bed Transfer ‐ Slide the patient onto the bed.
Transferring Patient From/To a Wheelchair
ƽ WARNING
ALWAYS engage the wheel locks of the bed and the wheel locks of the wheelchair
before transferring the patient between the bed and the wheelchair.
1. Engage the wheel locks of the bed. Refer to the owner’s manual provided with the bed.
2. Engage the wheel locks of the wheelchair, if applicable. Refer to the owner’s manual
provided with the wheelchair.
3. Press the Max Inflate button to achieve maximum mattress pressure.
4. Raise or lower the bed to match the wheelchair height. Refer to the owner’s manual
provided with the bed.
5. When the mattress has reached maximum firmness, perform one of the following:
• Bed to Wheelchair Transfer ‐ Slide the patient onto the wheelchair.
• Wheelchair to Bed Transfer ‐ Slide the patient onto the bed.
Preparing for CPR Procedure
NOTE: For this procedure, refer to FIGURE 2.5.
1. Perform one of the following:
• MA90Z Power Unit ‐ Press and hold the tabs on the hose connector (Detail “B”).
• MA95Z Power Unit ‐ Lift the connector cover (Detail “A”).
2. Pull the hose connector (Details “B” and “C”) from the control unit connectors.
NOTE: MA95Z Only ‐ If the hose connector is difficult to release, pull the hose connector down
and then away.
3. MA90Z Only ‐ Disconnect the RED CPR connector located on the hose (Detail “D”).