Acumen AiP-Y14D - Manual (Page 13)

12
Synchronize with a PC
A user can synchronize the PC system timer to the IP camera's system timer.
Chapter 3-3-4 System Setting
Load Default feature allows to load manufacturing default. There are certain critical settings such as
IP addresses and video system which are not affected by this operation. To reboot H.264 HD video
server or IP PTZ camera, click on Reboot System hyper link.
To update firmware of H.264 HD video server or IP PTZ camera, please click on Firmware
Update hyper link. Locate “flasham.bin” in your computer by clicking the Browse button. Click
Submit button to finish firmware upgrade. To ensure the quality of transmission, please make sure
that there is no user accessing H.264 HD video server or IP PTZ camera during firmware upgrade.
Chapter 3-4 Network
H.264 HD video server or IP PTZ camera provides Internet protocols including IP, DHCP, and DDNS.
A user can configure these Internet protocol settings. To setup above, please read the following
sections:
Chapter 3-4-1 General Settings
Network general settings are the basic settings connecting H.264 HD video server or IP PTZ camera
to the network. The default IP Address of H.264 HD video server or IP PTZ camera is
192.168.0.200. A user can use this IP address to verify the network connection between a local PC
and H.264 HD video server or IP PTZ camera using Web Browser.
For local area network configuration, please enter, at least, IP address, Subnet Mask, and Gateway
IP. Click Submit button to update these settings.
Note: In case of forgetting the password, the device is required to send back to our company for a
manufacturing default or read appendix for emergency default.