Acumen AiP-Y14D - Manual (Page 6)

5
Chapter 2 Before Accessing IP Camera
Before accessing to the IP camera, make sure that the camera’s RJ-45 network cable, audio cable,
and IP camera’s power cable are properly installed. For setup IP address, please consult your
network administrator for available IP addresses. The default IP address of IP camera is
192.168.0.200. User can also use default IP address to verify IP camera’s network connection.
Chapter 2-1 Configure IP Address Using IPScan Utility
To configure IP address using IPScan utility, copy IPScan application from installation CD to your
local PC or execute IPScan software from installation CD directly. IPScan utility can also be
downloaded from our company website. To change IP address, subnet mask, gateway, or HTTP
port, please follow steps below:
 Run IPScan utility.
 Click on Refresh button. All available devices get listed in Device list box.
 Select the device item in Device list box.
 Edit or modify addresses in IP, Subnet Mask, Gateway, or HTTP Port edit box.
 Click on Apply button to configure the settings.
 Click on Refresh button to verify the settings.
Chapter 2-2 Configure IP Address Using HTML Page
To change IP address using HTML page, please first type the default IP address, 192.168.0.200, in
Internet browser and follow steps below:
 Logon H.264 HD video server or IP PTZ camera using default username and
password
—“admin” and “pass”.
 Click on “Configure” hyper link.
 Click on “Network->General” hyper link.
 Type or modify edit box for IP address, subnet mask, gateway, or HTTP connection port.
 Click on Submit button.
Note: Make sure that IPScan is version 1.0.0.31 or above.