Acumen AiP-Y14D - Manual (Page 29)

28
“Add/Edit IP Camera” dialog box gets prompted for editing an IP camera or a DVR.
In “Add/Edit IP Camera” dialog box, please enter the following information:
1.
Name: Name of the IP camera or DVR’s camera
2. Category: Please select AI.
3. Type: Select device type, AI D1/ AI HD/ AI DVR.
4. IP Address: Please type IP address, for example http://122.116.191.129:86 where 86 is the
port number.
5. Provide username and password information. For IP camera, the default username and
password are “admin” and “pass”. For DVR, the default username and password are “admin”
and “1111”.
Once above information is entered, please click “Save” button. You are able to see live video of the IP
camera or DVR’s camera.
Emergency Factory Default
To restore the server to factory default settings, please:
1. Hold Load Default Button or short Reset Cable for 10 seconds, then release the button or
Reset Cable.
2. After about 40 seconds, the network LED light is off, and then it becomes lit again.
3. This camera has completed the factory default setting, and it reboots.
4. Use IPScan scanning for the IP address of the IP device.
5. Launch Internet browser for the IP address of the IP device.
6. Type default username “admin” and password “pass” for enter web interface of the IP device.
SD Card Compatibility List
Manufacturer Size SDHC/SDSC
Sandisk 16GB SDHC
Sandisk 8GB SDHC
Transcend 8GB SDHC
Transcend 4GB SDHC
Sandisk 32GB SDHC