Acumen AiP-Y14D - Manual (Page 19)

18
■ Exposure
In the Exposure Mode Setting users can select Auto, Shutter, Iris and Fix four modes.
Exposure-Auto Mode
In this mode can adjust the parameter of the Brightness/Flickerless/AGC Limit/Shutter Limit.
Exposure-Iris Mode
In this mode can adjust the parameter of the Brightness/Shutter/Flickerless/AGC Limit.
Exposure-Shutter mode
In this mode can adjust the parameter of the Brightness/Lens Iris/AGC Limit/Shutter Limit.
Exposure-Iris Mode
In this mode can adjust the parameter of the Brightness/Lens Iris/Shutter/AGC/Flickerless.
Brightness
This parameter is to adjust the brightness of the image. (0 to 64)
Lens Iris
This parameter is to set the aperture value. The value of iris is adjustable from F1.6 ~ F32.
Shutter
This parameter is to set the shutter speed. The range of shutter speed is from x256~1/10k.
AGC
The value if gain is adjustable from 0 ~ 42.
Flickerless
Eliminate image flicker.
AGC Limit
This parameter is to set the maximum auto gain control. The value of AGC limit is adjustable from 0~42.
Shutter Limit
The value of Shutter Limit is adjustable from x256 ~ x1.
■ 3D-DNR
With the 3D Noise Reduction function, the processor analyzes pixel by pixel and frame by frame to
eliminate environmental noise signal so that the highest quality image can be produced even in low light
conditions.
3D-DNR Mode
3D-Digital Noise Reduction mode select.
Select OFF this function off.
Select ON It's always controlled.
Select AUTO It's controlled by darkness when it is dark.
3D-DNR LEVEL
When 3D-DNR MODE is ON or AUTO, 3D-DNR reduction level change. Low/Mid/High
■ WDR Function
Select D-WDR function. Off/Low/Mid/High
When the high luminance part and the low illumination part are detected, the suppression low illumination
part is raised, and a high luminance part is adjusted in the contrast.
■ White balance
A camera needs to find reference color temperature, which is a way of measuring the quality of a light
source, for calculating all the other colors. The unit for measuring this ratio is in degree Kelvin (K). Users
can select one of the White Balance Control modes according to the operating environment.
ATW1 Mode
Auto Tracking White Balance.
ATW2 Mode
Auto Tracking White Balance（a drawing in limitation of the color）.