Acumen AiP-Q4U - Manual (Page 49)

AiP-N series 16CH/9CH/4CH Manual
48
1.4-7 SMTP setup
NVR is capable of sending JPEG snapshots to an email account when an alarm event is triggered. To
enable this feature, you must type in the relevant email account information.
1.4-8 FTP setup
The NVR is capable of alarm snapshot to an FTP server. To enable this feature, you must type in the
relevant FTP account information.
1.4-9 Buzzer timer
Select a time period you wish the buzzer (on NVR) to sound for upon an alarm trigger. This can be set
between 1-100 seconds, it can be set to always or off as required.
1.4-10 Buzzer enable
Turns the audible warning buzzer (on NVR) on or off
1.4-11 Button sound
Enables or disables button sounds on NVR
1.5 Network setup
In order to connect the NVR to LAN or the Internet you require subnet mask, gateway and IP address.
Consult your system administrator for more information.
It is highly recommended that NVR’s are accessed on a high bandwidth network such as Gigabit LAN.
1.5-1 IP mode
Set the NVR to Static, DHCP, and PPPoE IP modes. It is highly recommended that NVR’s are accessed on
high bandwidth network such as Gigabit LAN’s.