ACU-RITE Micro-Line T - Manual (Page 28)

MICRO-LINE Reference Manual
TROUBLESHOOTING
25
A ROM memory error has occurred. Press the CLEAR
key to acknowledge the error. If the system does not
operate properly, contact your
MICRO-LINE distributor
for repair/replacement procedures.
A power loss has occurred. This message will appear
every time you power up the system and can be cleared
by pressing the
CLEAR key. If the E1 message appears
at any time other than at power up, a power interruption
has occurred and your current position may be lost. Re-
establish the datum if necessary. If the problem persists,
contact your distributor for repair/replacement proce-
dures.
A random access memory (RAM) error has occurred.
Press the
CLEAR key to acknowledge the error. If the
system does not operate properly, contact your MICRO-
LINE distributor for repair/replacement procedures.
A scale miscount error (invalid waveform) has occurred.
The E9 message will appear on the axis that has the
error. Press
CLEAR to reset the axis(es). Your current
position may be lost. Re-establish the datum if necessary.
If the system does not operate properly, contact your
MICRO-LINE distributor for repair/replacement proce-
dures.
Error Messages (General)
E1
E2
E3
E4
E9
When MICRO-LINE is powered up, it will run a series of tests to ensure
that the software is working properly. If an error message appears, refer
to the charts below for a diagnosis and solution.
An EEPROM memory error has occurred. Press the
CLEAR key to acknowledge the error. The datum and
setup information may be lost. These areas should be
checked and reestablished upon power up. If the problem
persists, contact your distributor for repair/replacement
procedures.
MLTmanual.QXD 2/12/02 4:10 PM Page 36