ACU-RITE Micro-Line T - Manual (Page 43)

40 MICRO-LINE Reference Manual
REFERENCE
7. Align to within .010” TIR to axis of travel and mark the sec-
ond end mounting hole. Drill and tap.
8. Attach the scale and align to within .010”TIR to axis
of travel.
9. For the top mounting, form indicate to within .010” TIR over
each mounting hole and mark hole location. Drill and tap all
remaining holes. Attach the scale and align to within
.010” TIR to axis of travel.
10. For end mounting form, after scale is attached and
aligned, insert mounting hole covers.
11. Ensure the axis is still at its center of travel and the reading
head is centered on the scale. Mark the reading head
mounting holes.
12. Move the axis and drill and tap for 8-32 (M4).
MLTmanual.QXD 2/12/02 4:10 PM Page 5