SUUNTO Cobra - Manual (Page 50)

48
4.2.2. DIVE PLANNING SIMULATOR [2
SIMPLAN]
The Dive Planning Simulator mode shows you the
present no-decompression limits. In this mode, you are
also able to add the desired surface interval increment to
present surface interval time, which allows you to plan
your dives in advance.
This mode is also used to add the desired surface
intervals for dive simulations. Add the desired surface
interval increment to present surface interval by
pressing the arrow down (TIME) and arrow up (PLAN)
buttons.
To enter the Dive Planning Simulator mode select
MODE- 2 SIMUL- 2 SIMPLAN (Fig. 4.19.).
NOTE! This display is only shown for repetitive
dives.
NOTE! The Dive Planning Simulator mode is
disabled in Gauge mode and in Error mode (see
section 3.9. “Error Conditions”).
Fig. 4.21. Dive Planning
Simulation.
Fig. 4.19. Dive Planning Simula-
tor mode. [2 SIMPLAN].
Fig. 4.20. Selected Dive Plan-
ning Simulator mode. Add
desired surface interval incre-
ment (to present shown surface
interval) by pressing TIME and
PLAN buttons. This display is
only shown for repetitive dives.
SELECT
TIME
SURF
OK
QUIT
DIVE
NO DEC TIME
MAX