Spicer Tandem Drive Axle Dual Range & Double Planetary 34,000-45,000 lbs - Manual (Page 36)

Power Divider Overhaul
Disassemble Power Divider Cover (Cont'd)
Step
6
(cont'd).
To remove the "larger-diameter"
sliding clutch,
first remove the
lockout (see Shift System Section).
Then remove the sliding clutch
and shift fork (with the two parts
engaged). Grasp the assembly
by hand and maneuver the
assembly past restrictions in
the power divider cover.
To remove the "smaller-diameter"
sliding clutch,
(used on earlier
model axles), the clutch can be
disengaged and removed without
removal of the lockout and shift
fork.
9. Axles with Lube Pump:
With
drive gear locknut previously
removed (step 2) and working
through power divider cover input
shaft bore, gently pry oil pump
drive gear from its shaft. See
steps 10 thru 12 for pump
disassembly.
7.
Remove oil seal from input
bearing cover. Remove bearing
cup from cover.
8.
Remove input shaft bearing
cone. Temporarily place lockout
sliding clutch over rear of input
shaft, teeth toward bearing cone.
Place shaft in press and remove
bearing cone.
10.
Remove oil pump cover cap
screws and lockwashers. Remove
pump cover and "O" ring.
11. *NOTE:
When used, remove
woodruff key from gear shaft,
Remove pump gears from power
divider cover.
12.
Unscrew and remove
magnetic screen from power
divider cover.
36