Spicer Tandem Drive Axle Dual Range & Double Planetary 34,000-45,000 lbs - Manual (Page 49)

Assemble Wheel Differential
NOTE:
Lubricate internal parts with gear lube during reassembly.
1.
Press bearing cones on support
cases (see photos).
IMPORTANT:
To prevent bearing
cone damage, use suitable sleeve
that only contacts the inner race
of the cone.
Pressing Bearing Cone on Large
Support Case
Pressing Bearing Cone on Small
Support Case
2.
Position high-speed clutch plate with chamfered end of clutch teeth
toward idler pinions. Press clutch plate on case.
IMPORTANT:
It is important that the ends of the dowel pins are recessed
1/8" below surface of the clutch plate. If pins extend beyond plate
surface, press pins to proper depth. Don't press them in too far.
3.
Place thrust washer and side
gear in differential case.
49