Spicer Tandem Drive Axles Service Manual D170, D190, and D590 Series - Manual (Page 11)

7
Inspection
Endplay Procedure
Check Input Shaft Endplay (Forward Axle)
Note: Before disassembling the power divider, measure and
record input shaft endplay.
1. Position dial indicator at yoke end of input shaft.
2. Push in on input shaft and zero the dial indicator.
3. Using a pry bar, move input shaft axially and mea-
sure/record endplay.
Adjustment
Correct endplay for a new assembly is 0.001" to 0.005". See
the “Input Shaft Endplay" procedure in the "Power Divider
Assembly” section for proper endplay adjustment procedure.
Check Output Shaft Endplay (Forward Axle)
1. Position dial indicator at yoke end of output shaft.
2. Push in on output shaft and zero the dial indicator.
3. Using a pry bar, move output shaft axially and mea-
sure/record endplay.
Adjustment
Correct endplay for a new assembly is 0.001" to 0.045". The
maximum endplay for a used assembly is no more than
0.045". If endplay is incorrect, contact Dana.
Inspection