Spicer Tandem Drive Axles Service Manual D170, D190, and D590 Series - Manual (Page 24)

20
Power Divider
Helical Gear Bushing Replacement:
a. If bushing removal is needed, the bushings
must exit from the thrust side of the helical side
gear.
b. Install bushings in helical side gear. Bushing
must be installed from the thrust side of the
helical side gear. See illustration for installation
depth.
7. Install the helical side gear thrust washer.
8. Install the v-ring seal to the sliding clutch.
9. Install the sliding clutch so that the teeth are facing
up.
10. If removed, press the new input bearing cone in
place until seated using the proper press sleeve or
bearing installer.
11. For High Entry Applications Only:
Install shaft/gear assembly. Proceed to step 13.
1
1 - Tap out bushings
3
1
2
4
6
1
5
1.25 to 1.75 mm
1 - Press
2 - Sleeve
3 - 1st bushing (press to shoulder)
4 - Shoulder
5 - Sleeve
6 - 2nd bushing (recess 1.25 to 1.75 mm)
1 - Press
2 - Press Tool
3 - Bearing
4 - Input shaft