Spicer Tandem Drive Axles Service Manual D170, D190, and D590 Series - Manual (Page 40)

36
Wheel Differential
Wheel Differential Disassembly - Forward Carrier Assembly
Before July 2013
During the following procedures, place the
differential assembly on a malleable surface to prevent
damage when removing components.
1. Remove the differential case capscrews.
2. Remove the flange half differential case and bearing
assembly. Use a screwdriver at the spider arm
machined slots of the case to loosen the flange from
the ring gear.
3. Remove the side gear thrust washers, side pinions
and differential spider from the plain half case.
4. Place a block under the plain half, use a rubber mal-
let to remove the ring gear.
5. Remove the bearing cones from the case halves
using suitable pullers.
IMPORTANT
1 - Spider Arm Slots
1