Spicer Tandem Drive Axles Service Manual D170, D190, and D590 Series - Manual (Page 42)

38
Wheel Differential
Wheel Differential Assembly - Forward Carrier Assembly
To prevent bearing damage, use suitable sleeve that only
contacts the inner race of the cone. A used bearing race
would be a suitable tool. This tool should have a slit cut if
the ID is the same as the flange OD.
1. Press the new bearing cone on the plain half and
flange half bearing boss using the proper press
sleeve or bearing installation tool.
2. Place the plain half side of the differential case on a
malleable surface.
4. Assemble the side pinions and thrust washers
onto the wheel differential spider. Apply a thin
coat of oil to the mating surfaces of the side
pinion and differential spider. Install the
wheel differential nest on top of the side gear
5. Install the flange half side gear and thrust washer.
Apply a thin coat of oil to the mating surfaces.
6. Install the ring gear. Align the capscrew holes.
IMPORTANT
1
1 - Match spacing of holes on each side of
spider slots
3. Install the side gear and thrust washer. Apply a thin
coat of oil to the mating surfaces of the side gear
thrust washer and plain half.