Spicer Tandem Drive Axles Service Manual D170, D190, and D590 Series - Manual (Page 21)

17
Power Divider
Manifold Assembly
1. Install the manifold assembly into the output side
gear bore in the carrier. Make sure the barbed nipple
is lined up with the open ing in the carrier casting.
2. Install the hose clamp on the hose, push the hose
onto the barbed fitting and slide the clamp over the
barbed nipple.
3. Route the suction end of the hose through the holes
in the carrier casting to the bottom of the carrier.
4. Fully press the manifold assembly into position.
Note: Use care when pressing the manifold assembly to avoid
damaging the seals and barbed nipple. Do not over-
press plastic.
Note: For non-pump manifold installation, it is important to
line up the oil inlet path hole in the manifold with the oil
path opening in the carrier manifold casting.
5. Attach the suction screen to the end of the hose.
If the unit does not have a pump, go to the Power Divider
Assembly section.
If the unit contains a pump, go to the Pump Assembly section.
1
1 - Barbed Nipple
1 - Manifold Oil Inlet Hole
1
Power Divider