TROY Group MICR_IRD 4300 Security Printing Solutions User’s Guide - Manual (Page 90)

Section 5 Installing the TROY Support Files
Security Printing Solutions User’s Guide -- Document #50-70376-001 Rev. D
5-4
STEP 2
:
Install the
TROY
Support Files
for Windows
™
(cont.)
10. Click on the file (located in the left-hand window) named TroySEC.hpd or TroySECINTL.hpd (for
International customers), and then click on Open or OK (the displayed window may vary depending on the
operating system being used). With some printer drivers, the Add Font DIMM window will appear. If this
window appears, click on OK to close the window.
11. Within the Configure Font DIMMs window, verify the installation by clicking on the Font DIMM Name:
TROY Security Font Collection or TROY International Security Font Collection listed under Installed
DIMMs. Within the Fonts on DIMM list, the TROY E-13B (enabled) along with other TROY fonts will be
displayed.
12. Repeat Steps 9 through 11 to install the barcode fonts. Double-click on the barcode folder on the CD, and
select the TroyBAR.hpd file. Verify the installation by clicking on the Font DIMM Name: TROY Barcode
Font Collection listed under Installed DIMMs. Within the Fonts on DIMM list, the TROY barcode fonts
will be displayed.
13. Close all remaining open windows. Please refer to Section 8 – Using TROY Fonts before using the installed
fonts.