TROY Group MICR_IRD 4300 Security Printing Solutions User’s Guide - Manual (Page 107)

Section 6 Using the TROY Port Monitor
Security Printing Solutions User’s Guide -- Document #50-70376-001 Rev. D
6-6
Using the
TROY Port
Monitor
Connection Tab
Port monitor settings for the selected TROY Security Printing Solution and associated port will remain in effect
until changed by the user. If the administrator has set up user names and passwords, the user must enter a valid
user name and password before any port monitor security settings will affect the MICR print job initiated by that
user. For non-MICR print jobs, a user name and password is not required, and none of the TROY Port Monitor
security settings will affect the print job.
The Connection tab is used to select the type of port
(local or network) you are using to send print data to
the TROY printer.
TCP/IP – select this port if you are sending print data
from your computer to a TROY printer over a public
(Internet) or private (intranet) network. You must
specify a TCP/IP address and port number. The
TROY port monitor also supports UNC (universal
naming convention) paths.
File – select this port if you want to save your print
data in a file for archiving or for printing the job at a
later time.
LPT (1-4) – select this port (LPT1 through LPT4) if
you are sending print data from your computer to a
local printer connected directly to the parallel port of
your computer.
USB (Universal Serial Bus) – select this port if you
are sending print data from your computer to a
TROY printer connected to the USB port of your
computer.