Veris Technologies pH Manager - Operating Instructions - Manual (Page 39)

Pub.# OM17-MSP-pH
4-10
4. Insert pH electrodes into electrode holder. Finger-tighten plastic screws. Install BNC cover
on external controller to keep moisture out of BNC connectors. Leave BNC cover on
whenever unit is outdoors.
5. Row cleaner/firming wheel: Pull MSP forward and check depth of row cleaner and firming
wheel. Cleaner should be clearing residue ahead of sampling shoe, but not gouging into
soil. Adjust height of cleaner relative to firming wheel by removing adjustment pin and re-
positioning disk attachment.
• Pinch point hazard: to prevent injury, stand clear when raising or lowering any part of the Veris
MSP. Disengage automatic cycling function before working around unit. Install all transport locks
before transporting or working underneath.
Figure 19
6. Closing disks (if equipped): Adjust closing disks as needed to properly close trench and
bring residue over row-cleaned zone. Do not operate these deeper in soil than necessary.
Figures 20a and 20b
Closing Disks
depth adjustment
pin
Closing disk
angle
adjustments
Adjust height of cleaner
relative to firming wheel by
removing adjustment pin
and re-positioning disk
attachment.