VEGA VEGAMET 515 - Manual (Page 19)

VEGAMET 515 19
In the menu items "Pos. D“ and "Pos. E“ you
can determine if "Correction input 4“ or "Cor-
rection input 5“ is to be used for one of the
stated corrections. You only then have to
enter under "Parameter adjustment“ – "Spe-
cial functions“ in the menu items "Real value
correction at…“ or "Density correction at…“ a
value at which the correction should be car-
ried out.
Note!
For tare and monitoring, it is also possible to
assign input 4. However, it must not be used
for tare, monitoring and e.g., density correc-
tion, at the same time!
In the menu item "TAG-Name“, you can enter
an individual name for the measurement loop.
If you choose "Fault signal off“, the fail safe
relay and the fault indicator LED in the front
plate do not function. For a description of the
correction modes, see the following pages.
Configuration
Level measurement
Gauge measurement
Process pressure measurement
Differential pressure measurement
Pos. A
Pos. A
Pos. A
Two independent single measurements
Pos. A
Pos. A
Pos. A