VEGA VEGAPULS 62 (≥ 2.0.0 - ≤ 3.8) 4 … 20 mA_HART four-wire - Manual (Page 38)

Note:
S
ince with the function "Quick level change > 1 m/min." the generation
of an average value of the signal processing is considerably reduced,
false reflections by agitators or vessel installations can cause
measured value fluctuations. A false echo memory is thus recom-
mended.
T his function enables reading out parameter adjustment data as well
as writing parameter adjustment data into the sensor via the indicating
and adjustment module. A description of the function is available in the
operating instructions manual "Indicating and adjustment module".
T
he following data are read out or written with this function:
l M easured value presentation
l A djustment
l M
edium
l I nner diameter of the standpipe (with standpipe versions)
l V essel form
l D amping
l L
inearisation curve
l S ensor-TAG
l D isplayed value
l D isplay unit
l S caling
l C urrent output
l U nit of measurement
l L
anguage
T he following safety-relevant data are not read out or written:
l HART mode
l PIN
l SIL
C opy sensor data
C opy sensor data?
Basic adjustment
I
f the "Reset" is carried out, the sensor resets the values of the
following menu items to the reset values (see chart): 1)
Menu item Reset value
M ax. adjustment 0 m(d)
1) S ensor-specific basic adjustment.
Copy sensor data
Reset
38 VEGAPULS 62 • 4 … 20 mA/HART four-wire
6 S et up with the indicating and adjustment module PLICSCOM
28440
-EN
-090305