VEGA VEGAMET 624 - Manual (Page 18)

18
6 Setup with the integrated display and adjustment unit
VEGAMET 624 • 4 … 20 mA/HART
28969-EN-130701
The main menu is divided into six areas with the following functions:
•
Device settings: Includes the device-TAG, settings for network
connection such as date/time setting, …
•
Measurement loop: Includes settings for input selection, adjust-
ment, damping, linearization, scaling, outputs, …
•
Display: Includes settings to the displayed measured value
•
Diagnosis Includes information to the device status, error mes-
sages, input current
•
Service Includes simulation, reset, PIN, selectable language,
sensor address, …
•
Info: Shows serial number, software version, last change, instru-
ment features, MAC addr., …
→
Select the menu item "Device settings" with [->] and confirm with
[OK].
You can assign an unambiguous name to VEGAMET 624 via the
Device-TAG. This function is recommended when several instruments
are implemented and a good documentation of larger systems is
required.
→
Enter the requested values via the appropriate keys and save
your settings with [OK].
For instruments with integrated Ethernet interface, the automatic
addressing via DHCP is preset, i.e. the IP address must be assigned
by a DHCP server. Generally the instrument is contacted via the Host
name. By default, the host name consists of the serial number plus
"VEGA-" in front. As an alternative, it is also possible to enter a static
IP addr. with Subnet mask and optional Gateway addr.
Note:
Keep in mind that your modification will be only effective after a restart
of VEGAMET 624. You can find further information of these network
parameters in the supplementary instructions "RS232/Ethernet con-
nection" and in the Online help of the respective DTM.
Carry out your settings via the appropriate keys and save with [OK].
Main menu
Device settings - Device-
TAG
Device settings - Host
Name/IP addr.