VEGA VEGAVIB 62 Cable shortening set - Manual (Page 12)

14 Slide the individual parts (14, 15, 16, 17, 18, 19) according
to the drawing onto the cable.
Make sure that the shoulder of the washer (17) points to
the pressure ring.
15 Remove the outer insulation of the cable over a length of
100 mm (4 in).
16 Shorten the suspension cable (12) with a bolt cutter by
70 mm (2.8 in) (remaining length: 30 mm/1.2 in).
6 9 12 10 7
30mm
(1 3 /
16
")
100 mm
(3 15 /
16
")
Fig. 9: Shorten the suspension cable - slide on the cable clamp
6 Pins
7 Cable clamp
10 Perforated disc
12 Suspension cable
17 Place the perforated disc (10) onto the bare suspension
cable (12) and lead the 4 wires (green, yellow, red, green-
yellow) separately through the outer holes of the perforated
disc (10).
Do not lead the beige plastic cords (11) through the
perforated disc.
18 Slide the cable clamp (7) flush onto the suspension cable
(12). While doing this, turn the cable clamp in the direction
of the cable twist to avoid fraying the wire rope. The
chamfered side facilitates insertion of the cable.
19 Tighten the threaded pins (6) evenly on all sides with an
Allen wrench 2 mm. The threaded pins should all be
screwed in to the same depth in the cable clamp (approx.
3 Nm / 2.2 lbf ft).
20 Cut the beige plastic cords as short as possible with side
cutters.
12 VEGAVIB 62 • Cable shortening set
Mounting
30097
-EN
-080310