VEGA VEGAVIB 62 Cable shortening set - Manual (Page 15)

1 2 3 14 19
Fig. 13: Connect cores with crimping tools
1 Crimp connector - yellow (2 pcs.)
2 Crimp connector - red (3 pcs.)
3 Shrinking hose - blue
14 Pressure screw
19 Upper part of the oscillator
26 Assemble the parts of the vibrating element (A + B).
Provide the thread with screw retention. Make sure that no
wires get squashed.
The cable must not turn.
14 A B
Fig. 14: Screw the vibrating element together
14 Pressure screw
A Upper part of the oscillator
B Lower part of the oscillator
27 Screw the parts of the vibrating element together tightly. To
do this, clamp the lower part of the oscillator (B) into the
bench vice and turn only the upper part of the oscillator (A).
The cable must not turn.
28 Pull the cable (9) to the top and press the seal rings (18)
and the washer (17) into the upper part of the oscillator
(19).
29 Slide the pressure screw (14) and the pressure ring (15)
onto the rubber jacket (16).
VEGAVIB 62 • Cable shortening set 15
Mounting
30097
-EN
-080310