VEGA VEGAVIB 62 Cable shortening set User Manual
Page 9
Advertising
L
neu
L
145 mm
(5
45
/
64
")
9
Fig. 2: Cut the cable with a bolt cutter
9
Cable
5 Cut the cable (9) with a bolt cutter approx. 145 mm (ca.
5.7 in) above the new sensor length (L).
6 Clamp the upper part of the oscillator (19) in a bench vice.
14
9
Fig. 3: Loosen the pressure screw
9
Cable
14 Pressure screw
7 Unwind pressure screw (14) with a fork wrench SW 24 so
that the cable does not turn during the following dis-
assembly.
8 Clamp the lower part of the oscillator (below the screwed
separating position) in the bench vice.
Do not clamp on the fork tines.
VEGAVIB 62 • Cable shortening set
9
Mounting
30097
-EN
-080310
Advertising