5 switch-on phase – VEGA VEGASON 63 4 … 20 mA_HART - two-wire User Manual
Page 23
Advertising
23
5 Connecting to power supply
VEGASON 63 • 4 … 20 mA/HART - two-wire
28777-EN-130417
I2C
1
1
2
Fig. 22: Wiring plan, double chamber housing
1 Voltage supply, signal output
5.5 Switch-on phase
After connecting VEGASON 63 to power supply or after a voltage
recurrence, the instrument carries out a self-check for approx. 30
seconds:
•
Internal check of the electronics
•
Indication of the instrument type, the firmware as well as the sen-
sor TAGs (sensor designation)
•
Output signal jumps briefly (approx. 10 seconds) to the set fault
current
Then the corresponding current is outputted to the cable (the value
corresponds to the actual level as well as the settings already carried
out, e.g. factory setting).
Wiring plan
Switch-on phase
Advertising