8 switch on phase – VEGA VEGABAR 63 4 … 20 mA_HART User Manual
Page 30
Advertising
5.8 Switch on phase
A
fter connecting VEGABAR 63 to power supply or after a voltage
recurrence, the instrument carries out a self-check for approx. 30
seconds:
l
I
nternal check of the electronics
l
I
ndication of the instrument type, the firmware as well as the
sensor TAGs (sensor designation)
l
O
utput signal jumps briefly (approx. 10 seconds) to the set fault
current
T
hen the corresponding current is outputted to the cable (the value
corresponds to the actual level as well as the settings already carried
out, e.g. factory setting).
Switch on phase
30
VEGABAR
63 • 4 … 20
mA/HART
5 C
onnecting to power supply
32462
-EN
-081209
Advertising