VEGA VEGABAR 63 4 … 20 mA_HART - Manual (Page 37)

5 C onfirm with [+] and move to max. adjustment with [->].
T
he min. adjustment is finished.
Information:
F
or an adjustment with filling, you simply enter the displayed actual
measured value. If the adjustment ranges are exceeded, the message
"O
utside parameter limits" appears. The editing procedure can be
aborted with [ESC] or the displayed limit value can be accepted with
[OK]
.
P roceed as follows:
1 E dit the % value in the menu item "Max. adjustment" with [OK].
M ax. adjustment
+100 .0 %
=
+1000 .0 mbar
0000.0 mbar
Information:
T
he displayed pressure for 100 % corresponds to the nominal
measuring range of the sensor (in the above example 1 bar =
1000
mbar).
2 S et the requested percentage value with [->] and [OK].
3 E
dit the requested mbar value with [OK].
4 S et the requested mbar value with [+] and [->].
5 C onfirm with [OK] and move to the menu overview with [ESC].
T he max. adjustment is finished.
Information:
F
or an adjustment with filling, you simply enter the displayed actual
measured value. If the adjustment ranges are exceeded, the message
"O
utside parameter limits" appears. The editing procedure can be
aborted with [ESC] or the displayed limit value can be accepted with
[OK]
.
Process pressure measurement
S et up VEGABAR 63 in the following sequence:
1 S elect application "Process pressure measurement"
2 S elect the unit of measurement
3 C arry out position correction
4 C arrying out zero adjustment
5 C arrying out span adjustment
I
n the menu item "Adjustment unit" you select the physical unit in which
the adjustment should be carried out, e.g. mbar, bar, psi…
Carrying out max. ad-
justment
Parameter ad-
justment "Proc-
ess pressure
measurement"
VEGABAR 63 • 4 … 20 mA/HART 37
6 S et up with the indicating and adjustment module PLICSCOM
32462
-
EN
-081209