VEGA VEGABAR 63 4 … 20 mA_HART - Manual (Page 39)

▶ B asic adjustment
D isplay
D iagnostics
S ervice
I nfo
2 C onfirm the menu "Basic adjustment" with [OK], the menu item
"U nit" will be displayed.
U nit
U nit of measurement
bar ▼
T emperature unit
°C ▼
3 A ctivate the selection with [OK] and select "Units of measure-
ment
with [->].
4 A ctivate the selection with [OK] and select the requested unit with
[->] ( in the example mbar).
5 C onfirm with [OK] and move to position correction with [->].
T he adjustment unit is hence switched over from bar to mbar.
P roceed as follows to select the temperature unit: 6)
à Activate the selection with [OK] and select "Temperature unit
with [->].
à Activate the selection with [OK] and select the requested unit with
[->] ( e.g. °F).
à Confirm with [OK].
T
he temperature unit is hence switched over from °C to °F.
P
roceed as follows:
1 A ctivate in the menu item "Position correction" the selection with
[OK] .
P osition correction
Off set
P =
+ 0000 mbar
53 mbar
2 S elect with [->], e.g. to accept actual measured value.
P osition correction
A ccept current measured
value?
▶ A ccept
E dit
3 C onfirm with [OK] and move to min.(zero) adjustment with [->].
6) S election options: °C, °F.
Carry out position cor-
rection
VEGABAR 63 • 4 … 20 mA/HART 39
6 S et up with the indicating and adjustment module PLICSCOM
32462
-
EN
-081209