VEGA MINITRAC 31 4 … 20 mA_HART - four-wire - Manual (Page 46)

46
6 Set up with the display and adjustment module
MINITRAC 31 • 4 … 20 mA/HART - four-wire
40447-EN-131119
Menu Menu item Default value
Setup Measurement loop name Sensor
Isotope Cs-137
Application Density
Background radiation 0 ct/s
Unit of the process value g/cm 3
Temperature unit ° C
Adjustment min. process
value
0.500 g/cm 3
Adjustment max. process
value
1.500 g/cm 3
Inner diameter 0.20 m
Linearization 90000 ct/s and 0.500 g/cm 3
Damping 60 s
Real value correction 0
Current output mode 4 … 20 mA, < 3.6 mA
Current output Min./Max. Min. current 3.8 mA, max. current 20.5 mA
X-ray alarm Modulated measuring current
Reference value - Relay None
Block adjustment Released
Display Language Selected language
Displayed value Pulse rate
Display unit ct/s
Additional adjustments HART mode Standard
Address 0
With this function you can select the mode.
The sensor offers the HART modes standard and multidrop.
The mode 'Standard' with the fixed address 0 (factory setting) means
output of the measured value as 4 … 20 mA signal.
This parameter is described in the operating instructions manual
"Display and adjustment module".
With this function
•
Load parameter adjustment data from the sensor into the display
and adjustment module
•
Write parameter adjustment data from the display and adjustment
module into the sensor
This parameter is described in the operating instructions manual
"Display and adjustment module".
Info
In this menu you will find the following menu items:
Additional adjustments/
HART mode
Additional adjustments -
Copy instrument settings
Info