VEGA WEIGHTRAC 31 4 … 20 mA_HART - four-wire - Manual (Page 33)

33
6 Adjustment with the display and adjustment module
WEIGHTRAC 31 • 4 … 20 mA/HART - four-wire
42374-EN-131119
6 Adjustment with the display and
adjustment module
6.1 Insert display and adjustment module
The display and adjustment module can be inserted into the sensor
and removed again at any time. It is not necessary to interrupt the
power supply.
Proceed as follows:
1. Unscrew the small housing cover
2. Place the display and adjustment module in the desired position
on the electronics (you can choose any one of four different posi-
tions - each displaced by 90°)
3. Press the display and adjustment module onto the electronics
and turn it to the right until it snaps in.
4. Screw housing cover with inspection window tightly back on
Removal is carried out in reverse order.
The display and adjustment module is powered by the sensor, an ad-
ditional connection is not necessary.
1
2
Fig. 20: Insert display and adjustment module
Note:
If you intend to retrofit the instrument with a display and adjustment
module for continuous measured value indication, a higher cover with
an inspection glass is required.
Mount/Dismount display
and adjustment module