Document Outline

• 1 About this document
  • 1.1 Function
  • 1.2 Target group
  • 1.3 Symbolism used
• 2 For your safety
  • 2.1 Authorised personnel
  • 2.2 Appropriate use
  • 2.3 Warning about incorrect use
  • 2.4 General safety instructions
  • 2.5 CE conformity
  • 2.6 Measuring range - permissible process pressure
  • 2.7 NAMUR recommendations
  • 2.8 Environmental instructions
• 3 Product description
  • 3.1 Configuration
  • 3.2 Principle of operation
  • 3.3 Packaging, transport and storage
  • 3.4 Accessories and replacement parts
• 4 Mounting
  • 4.1 General instructions to use the instrument
  • 4.2 Ventilation and pressure compensation
  • 4.3 Process pressure measurement
  • 4.4 Level measurement
  • 4.5 External housing
• 5 Connecting to power supply and bus system
  • 5.1 Preparing the connection
  • 5.2 Connection
  • 5.3 Wiring plan
  • 5.4 External housing with version IP 68 (25 bar)
  • 5.5 Switch-on phase
• 6 Set up with the display and adjustment module
  • 6.1 Insert display and adjustment module
  • 6.2 Adjustment system
  • 6.3 Parameter adjustment - Quick setup
  • 6.4 Parameter adjustment - Extended adjustment
  • 6.5 Saving the parameter adjustment data
• 7 Setting up sensor and Modbus interface with PACTware
  • 7.1 Connect the PC
  • 7.2 Parameter adjustment
  • 7.3 Saving the parameter adjustment data
• 8 Diagnosis, asset management and service
  • 8.1 Maintenance
  • 8.2 Diagnosis memory
  • 8.3 Asset Management function
  • 8.4 Rectify faults
  • 8.5 Exchanging the electronics module
  • 8.6 Exchange process assembly with version IP 68 (25 bar)
  • 8.7 Software update
  • 8.8 How to proceed in case of repair
• 9 Dismounting
  • 9.1 Dismounting steps
  • 9.2 Disposal
• 10 Supplement
  • 10.1 Technical data
  • 10.2 Basics Modbus
  • 10.3 Modbus register
  • 10.4 Modbus RTU commands
  • 10.5 Levelmaster commands
  • 10.6 Configuration of typical Modbus hosts
  • 10.7 Dimensions
  • 10.8 Industrial property rights
  • 10.9 Trademark