VEGA VEGAFLEX 82 Modbus and Levelmaster protocol - Manual (Page 61)

61
9 Diagnostics and service
VEGAFLEX 82 • Modbus and Levelmaster protocol
41833-EN-130314
Information:
Please keep the stated torque so that the max. tensile strength
remains.
The rod or cable of the probe can be shortened individually.
1. Mark the requested length with mounted measuring rod.
2. Cable: Loosen the three pins on the gravity weight
Cable ø 4: 6 hexagon 3
Cable ø 6, cable ø 8: hexagon 4
3. Cable: remove the pins
4. Cable: Pull the cable out of the gravity weight
5. Shorten the cable/rod with a cut-off wheel or metal saw at the
marking. Take note of the specifications in the following illustration
when shortening the cable.
6. Cable: shift the cable into the gravity weight (according to the
drawing)
Plastic coated cable: remove coating according drawing to 70 mm
(2.76 in).
7. Cable: Fasten the cable with three pins, torque 20 Nm
(14.75 lbf in)
Cable ø 4: 7 Nm (5.16 lbf ft)
Cable ø 6, cable ø 8: 20 Nm (14.75 lbf ft)
8. Enter new probe length and then carry out a fresh adjustment
(see "Setup procedure, Carrying out min. adjustment - Carrying
out max. adjustment").
3
1
2 2
A B
45 mm (1.77")
150 mm (5.91")
70 mm (2.76")
150 mm (5.91")
Fig. 34: Shortening the cable probe
A Gravity weight - cable ø 4 mm
B Gravity weight - cable ø 6 mm
1 Pins
2 Thread M12 for eye-bolt
3 Pins
Shorten cable/rod