VEGA VEGAPULS 62 (≥ 2.0.0 - ≥ 4.0.0) 4 … 20 mA_HART - two-wire, approval according to LPR radio standard - Manual (Page 47)

Delivery status: Restoring the parameter settings at the time of
shipment from the factory incl. the order-specific settings. A created
false signal suppression, user-programmable linearization curve as
well as the measured value memory will be deleted.
Basic settings: Resetting the parameter settings incl. special and
laboratory parameters to the default values of the respective instru-
ment. A created false signal suppression, user programmable
linearization curve as well as the measured value memory will be
deleted.
Setup: Resetting of the parameter settings to the default values of the
respective instrument in the menu item Setup. Order-related settings
remain but are not taken over into the current parameters. User-
generated false signal suppression, user-programmed linearization
curve, measured value memory as well as event memory remain
untouched. The linearization is set to linear.
False signal suppression: Deleting a previously created false signal
suppression. The false signal suppression created in the factory
remains active.
Peak values measured value: Resetting of the measured min. and
max. distances to the actual measured value.
The following table shows the default values of the instrument.
Depending on the instrument version, not all menu items are available
or differently assigned:
Menu Menu item Default value
Setup Measurement
loop name Sensor
Medium Liquid/Water
Bulk solids/Crushed stones, gravel
Application Storage tank
Silo
Vessel form Vessel bottom, dished boiler end
Vessel top, dished boiler end
Vesell height/
Measuring range Recommended measuring range, see
"
Technical data " in the supplement
Min. adjustment Recommended measuring range, see
"
Technical data " in the supplement
Max. adjustment 0,000 m(d)
Damping 0.0 s
Current output
mode 4 … 20 mA, < 3.6 mA
Current output
Min./Max. Min. current 3.8 mA, max. current
20.5 mA
VEGAPULS 62 • 4 … 20 mA/HART - two-wire, approval according to LPR radio standard 47
6 Set up with the indicating and adjustment module
41718
-EN
-120301