VEGA VEGAFLEX 82 Profibus PA - Manual (Page 13)

13
3 Product description
VEGAFLEX 82 • Profibus PA
44220-EN-130910
For sensors with double chamber housing the interface adapter
"DISADAPT" is also required for VEGADIS 81.
You can find further information in the operating instructions "VE-
GADIS 81" (Document-ID 43814).
The PLICSMOBILE T61 is an external GSM/GPRS radio unit for
transmission of measured values and for remote parameter adjust-
ment of plics ® sensors. The adjustment is carried out via PACTware/
DTM by using the integrated USB connection.
You can find further information in the supplementary instructions
"PLICSMOBILE T61" (Document-ID 37700).
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, BS 10, ANSI B 16.5,
JIS B 2210-1984, GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
31088).
The electronics module VEGAFLEX series 80 is a replacement part
for TDR sensors of VEGAFLEX series 80. There is a different version
available for each type of signal output.
You can find further information in the operating instructions manual
"Electronics module VEGAFLEX series 80".
The display and adjustment module can be optionally replaced by a
display and adjustment module with heating function.
You can use this display and adjustment module in an ambient tem-
perature range of -40 … +70 °C.
You can find further information in the operating instructions "Display
and adjustment module with heating" (Document-ID 31708).
If you are using an instrument with rod version, you can extend the
rod probe individually with curved segments and rod extensions of
different lengths.
All extensions used must not exceed a total length of 6 m (19.7 ft).
The extensions are available in the following lengths:
Rod: ø 16 mm (0.63 in)
•
Basic segments: 20 … 5900 mm (0.79 … 232 in)
•
Rod segments: 20 … 5900 mm (0.79 … 232 in)
•
Curved segments: 100 x 100 mm (3.94 … 3.94 in)
You can find further information in the operating instructions manual
"Rod extension VEGAFLEX series 80".
PLICSMOBILE T61
Protective cap
Flanges
Electronics module
Display and adjustment
module with heating
Rod extension