Banks Power Interface- Banks iQ 1996 & Later Vehicles with OBDII Diagnostics - Manual (Page 31)

97272 v.1.0
31
To change the Banks iQ’s settings and
alerts, press the ‘Wrench’ icon to open
the ‘Adjustments’ Menu. See Figure 27.
These settings include Screen Backlight,
Touch Screen Calibration, GPS Speed
Calibration, Units (units of measurement),
Battery Management, (battery life
indicator and sleep settings), Version
Info (details about the Banks iQ, Tuner,
and SpeedBrake system) and Tuner/
SpeedBrake Update (upgrade, update
device firmware).
Screen Backlight
The Banks iQ can automatically dim
the system monitor LCD brightness for
nighttime operation. You can set the
‘Screen Backlight’ value that will be used,
along with the daytime operating hours.
When operating outside these hours the
screen will dim to the value you specify.
NOTE: Values are saved as they are
changed.
You can manually override your ‘Screen
Backlight’ at any time by pressing on
the Day/Night Switch icon on the upper
left corner of your Banks iQ screen in
the Information or Economy Modes. See
Figure 28.
1.
Press the ‘Wrench’ icon in the
Information or Economy Modes.
2.
Press the ‘Screen Backlight’ button in
the ‘Adjustments’ menu. See Figure 27.
3.
See Figure 29. In the ‘LCD Properties’
screen, press ‘Enable’ to activate or press
‘Disable’ to deactivate the Auto Dimming
feature. The active selection will be
highlighted red.
4.
Touch the ‘Left’ or ‘Right’ arrow
buttons to adjust LCD brightness to the
desired level for daytime and nighttime
operation. Your brightness selection will
preview automatically as changes are
made.
5.
Set the transition time for auto
dimming by pressing the ‘Hour’ and the
‘Min’ (minute) buttons below the day and
night time.
6.
Press the ‘Banks iQ’ icon on the lower
left hand corner to return to the Current
Mode screen. Press the ‘Return‘ icon to
go back to the ‘Adjustments’ menu.
Touch Screen Calibration
1.
Press the ‘Touch Screen Calibration’
button in the ‘Adjustments’ menu.
2.
Follow the on-screen instructions and
press the targets as they appear on the
display screen.
3.
Press the ‘Banks iQ’ icon on the
lower left hand corner to return to the
‘Adjustments’ menu.
GPS Speed Correction
The Banks iQ speedometer uses GPS
Speed Correction to deliver improved
accuracy over your vehicle’s stock unit. It
even corrects for non-stock wheels and
tires. Calibration is simple and there is no
need to use a pace vehicle or manually
input tire size.
1.
Find an open, uncrowded stretch of
road.
2.
Press the ‘GPS Speed Correction’
button.
Section 15
SET-UP
Figure 28
Day/Night
Switch Icon